These Rebar Stakes are available in 18", 24" and 30" lengths by the 1/2 dozen or the dozen. They are designed for use for land trapping and are constructed of 1/2" rebar with a heavy duty flat washer welded to the top and an angle-cut bottom. These stakes are designed to be hammered into the ground.

These T-Bar Stakes are available in 18", 24", 30" and 36" lengths by the 1/2 dozen or the dozen. They are designed for use for water trapping and are constructed of 3/8" rebar with a 4" length of rebar welded to the top and a pencil point ground bottom. These stakes are designed to be pushed into the ground.

These Wooden Stakes are available in 18" and 24" lengths by the 1/2 dozen or dozen. They are made of hardwood. They have a hole drilled through them approximately 1" from the top for easy insertion of wire up to 11 gauge in size and have a sharp cut bottom to make them easier to drive into the ground.

These Wooden Marsh Stakes are approximately 46" in length and are made of hardwood. They have two holes drilled through them for easy insertion of wire up to 11 gauge in size. This gives you two different anchoring points depending on how deep into the water you drive these stakes. The first hole is 1 1/2" from the top of the stake and the next hole is approximately 13" lower. These Marsh Stakes have sharp cut bottoms to make them easier to push into the muck when marsh trapping. Being made of hardwood they are also tough enough to be driven into soft ground for use as tie offs when using body grip traps on land.